hello
i have done the upgrade with a Transcend 4 GB NAND.
made a connector for 40 pin ide.
made an image off the original xpe.
copied the image on the 4 gb.
made sure it will boot - using a pc.
pluged it in with NO pin 44.
and the following apears:
no boot device present Halting.
tryed jumpering it master/slave no jumper - nothing workes....
i am sure the image was copied good, and the flash hd works.
any one knows what should i do?
internal ide flash upgrade
-
- Administrator
- Posts: 569
- Joined: Tue Mar 24, 2009 9:11 pm