HDD1 IDE Pinout
1 RESET
2 GND
3 DATA 7
4 DATA 8
5 DATA 6
6 DATA 9
7 DATA 5
8 DATA 10
9 DATA 4
10 DATA 11
11 DATA 3
12 DATA 12
13 DATA 2
14 DATA 13
15 DATA 1
16 DATA 14
17 DATA 0
18 DATA 15
19 GND
20 KEY (NO CONNECTION)
21 DMARQ
22 GND
23 DIOW-
24 GND
25 DIOR-
26 GND
27 IORDY-
28 CSEL
29 DMARK-
30 GND
31 INTRQ
32 IOCS16-
33 DA1
34 PDIAG
35 DA0
36 DA2
37 CS1FX-
38 CS3FX-
39 DASP-
40 GND
41 VCC LOGIC
42 VCC MOTOR
43 GND
44 TYPE (0=ATA)
NOTE: It is possible to use alternate drives on this bus by not using pins 41 and 42. these leads can be powered alternately from the usb 5v. please note that usb only allows up to 500mA. Also you can connect to a 40 pin ide channel by not making connections to the last 4 pins ie standard hard drive.
I have tried to connect a standard hard drive via a 40 pin cable soldered directly to the board. The bios will recognize this drive, however I have not been cleaver enouch to get it to allow me partition it. when running fdisk under dos, I get a Integer devide by zero error and when i use the /x switch, i can partition the drive but after reboot, it is not there anymore. Not sure what is happening there. Perhaps I will try with a laptop hard drive.
DT366 HDD1 IDE Pinouts
Topics on hardware and modifications. Please post your "how to" steps that involve tools here.
-
- Newbie
- Posts: 8
- Joined: Wed Nov 24, 2010 8:56 pm
Return to “Specifications / Hardware”
Jump to
- Welcome to WebDT.org!
- ↳ Welcome to WebDT
- ↳ FAQ
- ↳ Where did you get yours?
- ↳ How are you using yours?
- WebDT366
- ↳ Specifications / Hardware
- ↳ General Discussion
- ↳ Bios Settings
- ↳ Linux on a WebDT366?
- ↳ Windows on a WebDT366?
- ↳ The Collective
- WebDT360 / Atigo S
- ↳ Specifications / Hardware
- ↳ General Discussion
- ↳ Bios Settings
- ↳ Linux on a DT360 / Atigo S
- ↳ Windows on a DT360 / Atigo S
- WebDT368 / Atigo T
- ↳ Specifications / Hardware
- ↳ General Discussion
- ↳ Bios Settings
- ↳ Linux on a DT368 / Atigo T
- ↳ Windows on a DT368/ Atigo T
- WebDT375 / Atigo M
- ↳ Specifications / Hardware
- ↳ General Discussion
- ↳ Bios Settings
- ↳ Linux on a DT375 / Atigo M
- ↳ Windows on a DT375 / Atigo M
- Other models
- ↳ This area is for any other model of Atigo or WebDT that does not have its own section
- Events
- ↳ Events